Configuring h-encore

Configuring h-encore

Required Reading

If your device was unable to downgrade to either 3.60 or 3.65 due to its “factory firmware”, you will be unable to use the more convenient Ensō boot-time exploit.

As a result, you will have to perform the h-encore exploit manually after each reboot. To make this slightly more convenient, we will disable the “trophy warning” that currently appears on every launch of the h-encore exploit.

Instructions

Section I - Disabling Trophy Warning

1. Launch the h-encore application while holding (R)
2. Select “Personalize savedata”
3. Select “Exit”