Installing boot9strap (SafeB9SInstaller)
Instructions
Section I - Launching SafeB9SInstaller
1.Launch udsploit from the list of homebrew2.Once it has completed, press (Start) to exit udsploit
- This may take several tries
- If it freezes, just force the console to power off by holding the power button, then try again
- If you get a “PM INIT FAILED” error, make sure you ran udsploit with Wireless Communication turned on
- If you still get a “PM INIT FAILED” error, try using the r19 release of safehax
- If it freezes, just force the console to power off by holding the power button, then try again
Section II - Installing boot9strap
- Wait for all safety checks to complete
- When prompted, input the key combo given to install boot9strap
- Once it has completed, press (A) to reboot your device
Section III - Configuring Luma3DS
1.Your device should have rebooted into the Luma3DS configuration menu
- If you get a black screen, follow this troubleshooting guide
- “Show NAND or user string in System Settings”
- If you get an error, just continue the next page
0 Comments